Danger Of Fire - EuroLite Mirrorball-Set 30 Bedienungsanleitung

Rigging
The installation of the Pinspot has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The Pinspot should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the Pinspot. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger. Improper installation can result in bodily injury and.or
damage to property.
The Pinspot has to be installed out of the reach of people.
If the Pinspot shall be lowered from the ceiling or high joists, professional trussing systems have to be used.
The Pinspot must never be fixed swinging freely in the room.
Caution: Pinspots may cause severe injuries when crashing down! If you have doubts concerning the safety
of a possible installation, do NOT install the Pinspot!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the Pinspot's
weight.
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
Mount the Pinspot with the mounting-bracket to your trussing system using an appropriate clamp.

DANGER OF FIRE!

17/42 50101860_V_1_2.DOC