Cable Remote Control; Wireless Remote Control - EuroLite Dynamic Fog 1200 Bedienungsanleitung

Cable Remote Control

For cable remote control operation, disconnect the DMX cable from the unit. Once the green LED lights up,
the machine is ready to emit fog.
Manual Fog Output
To manually activate a fog output, press the green MANUAL button. While this switch is
kept pressed, the unit will emit the maximum amount of fog. As soon as you release the
button, the fog output will stop.
The manual mode will take priority over the continuous and timer mode, i.e. when the
green button is pressed, the unit will always emit fog even if one of the other modes is
activated.
Continuous Mode
In the continuous mode, the fog machine will emit fog continuously. To activate the
continuous mode, press the red button CONTINOUS, so that it will engage. To deactivate
the continuous mode, disengage the red button CONTINOUS again.
The continuous mode will take priority over the timer mode, i.e. when the red button is
pressed, the unit is set to continuous mode even if the timer mode is activated with the
button timer.
Timer Mode
In the timer mode, the fog machine will automatically emit fog. The time intervals and
duration are adjustable.
1
To activate the timer mode, press the yellow button TIMER so that it will engage and
the control indicator above the button starts flashing.
2
With the control INTERVAL, adjust the intervals between the individual fog outputs
between 0 and 30 minutes.
3
With the control DURATION, adjust the duration of the fog outputs between 1 and
15 seconds.
4
To deactivate the timer mode, disengage the yellow button TIMER again. The yellow
control indicator above it will be extinguished.

Wireless Remote Control

For operation, put the antennas at the fog machine and the remote control in a vertical position. When you
hold down any of the four trigger buttons, the fog machine will emit the maximum amount of fog. The
control LED lights. As soon as you release the button, the fog output will stop.
To set the remote control, press the button MENU until the display indicates "ErПo". Then press ENTER to
make your settings. Use the buttons ▲ and ▼ to deactivate the remote control (indication "off") and to
reactivate it (indication "on"). Once again, press ENTER to confirm your settings.
www.eurolite.de
24