Operation Via Wireless Remote Control; Dmx Control; Making The Conntections; Adjusting The Dmx Start Address - EuroLite N-150 MK2 Bedienungsanleitung

With the DIP switches (7) you can enable each of the four buttons on the remote control separately
for controlling the fog machine. To enable a button set the corresponding switch to the lower ON
position.
When you hold down one of the buttons, the fog machine will emit the maximum amount of fog. The control LED
lights. As soon as you release the button, the fog output will stop.
Note
The remote control allows simultaneous control of several fog machines. Either four separate units (one per
button) or you enable the same button for several machines (e.g. all machines assigned to button 1 will emit fog
when button 1 on the remote control is pressed).
Making the connections
The unit features 3-pin XLR plugs for DMX connection.
• Connect the output of your DMX controller to the DMX IN jack of the machine with a DMX cable.
• Connect the DMX OUT jack of the machine to the DMX input of the next unit in the chain. Always connect one
output to the input of the next unit until all units are connected.
• At the last unit, the DMX cable has to be terminated. Plug the terminator with a 120 Ω resistor between Signal (–)
and Signal (+) in the DMX output of the last unit.
• If the cable length exceeds 300 m or the number of DMX devices is greater than 32, it is recommended to insert
a DMX level amplifier to ensure proper data transmission.
Occupation of the XLR connection:

Adjusting the DMX start address

The fog machine reserves one control channel on the DMX controller. To ensure that the
control signals are properly directed to the machine, it must be adjusted to the DMX start
address provided for it on the DMX controller. The address is adjusted via the DIP
switches (9) as a binary number. The address will result when adding the place values of
the DIP switches set to "ON".
Please make sure that you do not have any overlapping channels in order to control each device correctly and
independently from any other fixture on the DMX data link. If two, three or more devices are addressed similarly,
they will work similarly.
DIP switch configuration:

OPERATION VIA WIRELESS REMOTE CONTROL

DMX CONTROL

20 • EN
DMX functions:
DMX value
0 – 5
6 – 255
Function
0 % fog output
5-100 % fog output