Basic Settings - Medion MSH 3002 Handbuch

Basic Settings

After switching on the receiver for the first time or after using the Factory Reset function
you will be asked to choose your OSD language and your geographical location. The re-
ceiver will also offer you the choice to perform a channel scan or if available to use a pre-
programmed channel list for your location. Note: these channel lists are only up-to-date
when the receiver is produced or a software update has been performed. Afterwards you
should perform the following steps:
1. Open the main menu.
2. Go to "Edit Settings"
3. Enter the "Satellite Systems" menu. Mark the satellite that you
want to receive by pressing the OK key. The activated satellites will
be marked with a Plus sign.
Leave the satellite list by pressing EXIT.
4. If you only receive the signals from one satellite please continue to
point 7 of these instructions.
If your satellite system allows you to receive more than one satel-
lite you can activate the integrated DiSEqC 1.0-switching system.
Enter the "Reception" menu to set up this feature.
5. Choose the heading "Equipment Control" and select "DiS-
EqC easy" using the arrow keys.
6. Choose up to four satellites that are connected to the inputs of
your switch in the "Satellite A –D" lines. If f.e. you only receive As-
tra 1 (19.2°E) and Hotbird (13.0°E), you would usually enter "As-
tra 1" as Satellite A and "Hotbird" as Satellite B.
Only satellites that have been activated in step 3 are available.
You can either use the left/right to select the satellites. If you
press OK the list of all activated satellites is displayed to simplify
the selection.
7. Go to "Signal Output". Select the screen format for your TV.
8. If you wish to control the volume through your receiver go to
point 9 of these instructions.
Reduce the volume of your TV and amplifier (Hi-Fi) to it's mini-
mum before carrying out the following steps.
If you wish to control volume from the connected device (amplifier,
TV, etc.) go to the heading "Volume-bypass" and choose the out-
puts for the source of the full volume level.
38
Press MENU
button twice
– / +
– / +
OK
– / +
– / +
OK
MSH 3002