Replacing The Lamp - Electrolux IK1345SL Benutzerinformation

70 www.electrolux.com
Problem
Water flows on the floor.
Temperature cannot be set. The Action Freeze or Shop-
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
Possible cause
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
ping function is switched
on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' temper-
ature is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
The Action Freeze function
is switched on.
The Shopping function is
switched on.

8.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Solution
Make sure that food prod-
ucts do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Switch off Action Freeze or
Shopping manually, or wait
until the function resets au-
tomatically to set the tem-
perature. Refer to "Action
Freeze or Shopping func-
tion".
Keep the Mode button
pressed for approximately
10 seconds until a long
sound is heard and display
shuts off for a short time.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if nec-
essary.
Refer to "Action Freeze
function".
Refer to "Shopping func-
tion".