Reloop RMP-2 MK2 Bedienungsanleitung Seite 29

(1/75 min.) a Cue Point. While in Play mode, use the Jog Wheel, similar to a
turntable, for pitch bending (during deactivated Scratch -27-). This is a quick
increase (push start) or decrease (stop) of the pitch. The faster the Jog
Wheel is turned, the quicker the change of pitch. The same effect can be
achieved with the Pitch Bend buttons -24-.
Also, the Jog Wheel can be used with the help of the Time and Ratio buttons
-25/26- to modulate and set effects and samples. For this, read more on the
individual effects -28 to 35- in the chapter entitled "Sampling".
19. Eject button
To insert a CD, slide the CD with the picture facing upwards carefully into the
slot -1-. The CD is automatically pulled in. The Status LED above the drive
flashes while loading the CD. As soon as the CD has been read and
recognised, the Status LED goes off. When playing CDs with a diameter of
less than 12 cm, use any conventional adapter. Press the Eject button -19- to
eject the CD.
20. Pitch Range button
Press the Pitch Range button -20- to select between a pitch range of +/- 4%,
+/-8%, +/-16% or +/-100%.
21. Key Lock button
When activating the Key Lock function with the button -21- the track's
original tone pitch, regardless of the set pitch, is maintained. Press the
button a second time to deactivate the Key Lock function.
22.Pitch Fader
Use the Pitch Fader -22- to infinitely change the pitch of the track within the
selected range. The difference from the original pitch is shown on the display
-11F- in per cent. Adjustments in the +/-4 % and +/- 8% pitch ranges are
effected in steps of 0,05%, in the +/- 16% pitch range in steps of 0,1% and in
the +/- 100% pitch range in steps of 1%
NOTE!
These steps can only be shown with one position after decimal point on the
display -11 F-. The accurate value will temporarily appear on the display -11
J- when using the pitch fader.
23. Pitch On/Off button
De-/Activate the Pitch Fader using the Pitch On/Off button -23-.
24. Pitch Bend buttons
Use the Pitch Bend buttons -24- to briefly change the pitch of the respective
track by +4/8/16% (+ button), or by -4/8/16% (- button) by holding it. Release
the button for the player to return to the pitch set with the Pitch Fader.
25. Parameter Time
Use the Parameter Time button to modulate a chosen effect or a sample
(beat frequency, pitch).
For more information read about the individual effects -28 to 35- or go to
the chapter entitled "Sampling".
NOTE:
The last activated effect or sample is always assigned to the parameter.
26. Parameter Ratio button
Modulate a chosen effect or a sample with the help of the Parameter Ratio
button. (intensity)
For more information read about the individual effects -28 to 35- or go to
the chapter entitled "Sampling".
29