Reloop RMP-2 MK2 Bedienungsanleitung Seite 21

- Do not operate the device under extremely hot (in excess of 35° C) or
extremely cold (below 5° C) conditions. Keep the device away from direct
exposure to the sun and heat sources such as radiators, ovens, etc. (even
during transport in a closed vehicle). Never cover the cooling fan or vents.
Always ensure sufficient ventilation.
- The device must not be operated after being taken from a cold environment
into a warm environment. The condensation caused hereby may destroy
your device. Do not switch on or operate the device until it has reached
ambient temperature!
- Controls and switches should never be treated with spray-on cleaning agents
and lubricants. This device should only be cleaned with a damp cloth. Never
use solvents or cleaning fluids with a petroleum base for cleaning.
- When relocating, the device should be transported in its original packaging.
- When starting operation the cross-faders and volume controls of your
amplifier must be set to minimum level. Bring the loudspeaker switches into
the "OFF" position. Wait between 8 to 10 seconds before increasing the
volume to avoid shot noise created by transient effect, which could cause
damage to loudspeakers and the diplexer.
- Always ensure that you place scratch-free, clean CDs into the player. When
placing the CD into the tray, your hands should also be clean.
- To keep the laser head clean always close the CD tray.
- Devices supplied by voltage should not be left in the hands of children.
Please exercise particular care when in the presence of children.
- At commercial facilities the regulations for the prevention of accidents as
stipulated by the association of professional associations must be observed.
- At schools, training facilities, hobby and self-help workshops the operation of
the device must be monitored with responsibility by trained staff.
- Keep this operation manual in a safe place for later reference in the event of
questions or problems.
ATTENTION:
In the unlikely event of a return, please use the original packaging only to
properly protect the equipment against any damage caused during
transport. Damage caused during transport as a result of improper
packaging could entail the cessation of the guarantee. The manufacturer
does not accept liability for damage caused during transport as a result of
improper packaging of a returned shipment to the seller. Such cost is for the
account of the sender!
21