Safety Regulations; Proper Use - EINHELL DSS 260/2 Bedienungsanleitung Und Wartungsanleitung

Anleitung_DSS_260_2_SPK1:_
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.

1. Safety regulations

CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
Take suitable precautions to protect yourself and
your environment from potential hazards.
Never put the impact screwdriver to any use
other than that intended. Keep pneumatic tools
safe from children.
Always concentrate while you work. Do not work
if you are tired.
Use only a quick-release coupling to connect up
the air supply.
It is imperative to use a pressure reducer to set
the working pressure.
Never use oxygen or combustible gases as an
energy source.
Always disconnect the tool from the air supply
before carrying out any repairs or maintenance
work.
Use only original replacement parts.
Never allow the tool to run unloaded at full idle
speed for any length of time.
Wear the necessary protective clothing when
working with the impact screwdriver.
Wear ear-muffs and safety gloves!
Compressors and lines reach high temperatures
during operation. Avoid contact! Risk of burns!
Gases or vapours drawn in by the compressor
have to be kept free of constituents that may
cause fire or explosions inside the compressor.
When you disconnect the hose coupling, hold the
coupling element in your hand to prevent injury
from the whiplashing hose.
8
20.01.2009 8:44 Uhr Seite 8
Wear goggles when working with the blow-out
gun. Injuries may easily result from foreign
bodies and blasted parts.
Never point the blow-out gun at other persons
and never use it to clean clothes that are still
being worn.
2. Layout (Fig. 1)
1 trigger lever
2 air regulator / torque regulator
3 selector pin Forward/Reverse
4 square drive for nut socket (mounting shaft)
5 plug-on nipple for the air supply
6 Adjustment screw

3. Proper use

The impact screwdriver is a handy pneumatic tool for
use in DIY and automotive workshops. It is ideal for
fastening and releasing threaded connections on
motor vehicles (wheels etc.) and on farming
equipment.
The exhaust air is released through the outlet at the
bottom. The socket-wrench inserts can be easily and
quickly exchanged. The compressed air connection
takes place through a nipple and quick-lock coupling.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
Repairs and maintenance work are to be carried out
only by authorized specialist workshops.
Please note!
The power of the tool will be reduced if you use a
hose that has too small an inner diameter or
which is too long.