Troubleshooting Guide - EINHELL CC-JS 18 Originalbetriebsanleitung

13. Troubleshooting guide

Fault
The equipment can-
not be switched on:
Jump starting does
not work
All LED fl ash
Anl_CC_JS_18_SPK7.indb 18 Anl_CC_JS_18_SPK7.indb 18
GB
Possible cause
- Battery voltage too low
- Battery voltage too low
- Connections on the vehicle con-
nected with reverse polarity
- Ambient temperature outside the
temperature range
- The overload cutout has responded
- Equipment too hot
- Ambient temperature too low/high
- 18 -
Remedy
- Charge battery
- Charge battery
- Check the polarity and connect cor-
rectly
- Try jump starting within the tempe-
rature range
- Switch off the equipment, check for
possible overloading
- Observe equipment temperature of
+ 10°C - + 40°C.
- Observe ambient temperature ran-
ge of – 15°C - + 40°C
08.01.16 11:32 08.01.16 11:32