Dehumidification - Siemens PA0840M Gebrauchsanweisung

J Plug the appliance into the mains electricity
supply.
J Lead the hot air expulsion tube outside,
(see "Preparing the appliance before use").
J Check that the plug is fitted onto the water
drainage pipe to prevent water from leaking
onto the support surface.
J Lift the air director on the top of the
appliance, Fig. 17.
J Turn the appliance on by pressing the "On"
key .
J Select the cooling function
"Selecting the operation function").
J Select the desired temperature, (see
"Selecting the temperature"). If the
appliance turns itself off automatically
because the desired temperature for the
room has been reached, it will not start
working again until ambient temperature
rises 2-3°C.
J Select the operation speed, (see "Selecting
the speed").
During air conditioning, the condensed water
produced evaporates automatically and is
expelled outdoors together with the expelled
air through the hot air expulsion tube.
In conditions of extreme humidity, the
appliance accumulates condensed water in
the appliance's rear tank. When a certain level
the appliance beeps twice. The removable
tank full symbol appears on the screen at
the same time to indicate that the tank needs
to be emptied. The appliance stops working
when this happens. To empty the removable
tank, press the handle and remove the tank
carefully. Empty the water down the nearest
drain.
Instructions for Use
The symbol disappears from the screen when
the water tank has been emptied and replaced
on the appliance properly.
Warning!
When you turn the appliance back on again
after emptying all of the water, do not forget
to replace the removable tank on the
appliance properly. Should you fail to do
so, the symbol will not disappear from the
screen and the appliance will not work.
Remember that when the appliance is
Fig. 17
turned off, it is necessary to wait for
approximately 3 minutes before the
compressor starts up again. This period of
time is required in order to ensure correct
appliance operation.

Dehumidification

In this operation function, the appliance
reduces the humidity in the atmosphere. The
appliance purifies the air in the room at the
, (see
same time in order to create a pleasant
atmosphere.
J Plug the appliance into the mains electricity
J Fit the hot air expulsion tube outside as
J Lift the air director on the top of the
There are two ways of expelling condensed
water: via the removable tank and in
continuous mode.
Dehumidification via the removable tank:
• Check that the removable tank is fitted onto the
• When the water in the removable tank reaches
• In both events, it is necessary to extract the
36
supply.
indicated in "Preparing the appliance before
use".
appliance.
appliance properly and that the plug is fitted
onto the water drainage pipe to prevent water
from leaking onto the support surface.
a certain level, the appliance beeps twice. T h e
removable tank full symbol
screen at the same time to indicate that the
tank needs to be emptied. The appliance stops
working when this happens. The symbol also
appears and the appliance beeps when the
removable tank is not properly fitted into its
h o u s i n g .
tank and pour the water carefully down the
nearest drain.
appears on the