Specifications - Ryobi cid-1802m Bedienungsanleitung

GB
F D
RULES FOR SAFE OPERATION
If under abusive conditions, liquid is ejected from
■
the battery, avoid contact. If this accidentally
occurs, flush with water. If liquid contacts eyes
additionally, seek medical help.
Do not place battery tools or their batteries near
■
fire or heat. This will reduce the risk of explosion and
possibly injury.
WARNING
Batteries vent hydrogen gas and can explode in
the presence of a source of ignition, such as a
pilot light. To reduce the risk of serious personal
injury, never use any cordless product in the
presence of open flame. An exploded battery can
propel debris and chemicals. If exposed, flush
with water immediately.

SPECIFICATIONS

Model
Voltage
Chuck
Switch
No load speed (drill mode):
- Lo speed
- Hi speed
No load speed (impact mode):
- Lo speed
- Hi speed
Max. Torque
Weight - incl. battery pack
Battery pack (Not included)
- 1.5/1.7 Ah
Charger (Not included)
FEATURES
1. Keyless chuck
2. Switch trigger
3. Direction of rotation selector (Forward/Reverse)
7. Screwdriver bits
5. Battery pack (Not included)
6. Latches
7. Torque adjusting Ring
E I P NL
CID-1802M
18 V
10 mm
Variable speed
0 - 400 min-
0 - 1400 min-
0 - 6400 min-
0 - 22400 min-
32 Nm
2.17 kg
BPP-1817M/1815M
BC-1800/BC-1815S
S DK N FIN GR
English
OPERATION
TO INSTALL BATTERY PACK (NOT INCLUDED)
Lock switch trigger on your drill by placing the
■
direction of rotation selector in center position.
See Figure 4.
Place battery pack in your drill. Align raised rib on
■
battery pack with groove inside drill. See Figure 2.
Make sure the latches on battery pack snap in place
■
and battery pack is secured in drill before beginning
operation.
TO REMOVE BATTERY PACK (NOT INCLUDED)
Lock switch trigger on your drill by placing the
■
direction of rotation selector in center position.
See Figure 4.
Locate latches of battery pack and depress to release
■
battery pack from your drill. See Figure 2.
Remove battery pack from your drill.
■
ADJUSTING THE TORQUE
See Figure 3.
The tool is equipped with an adjustable torque clutch for
driving different types of screws into different materials.
Adjust the torque as necessary.
1
1
We recommend that you use carbide-tipped bits and
select impact mode when drilling in hard material such
1
as brick, tile, concrete, etc.
1
SWITCH
See Figure 4.
To turn your drill ON, depress the switch trigger.
■
To turn it OFF, release the switch trigger.
■
VARIABLE SPEED
This tool has a variable speed switch that delivers
higher speed and torque with increased trigger pressure.
Speed is controlled by the amount of switch trigger
depression.
6
H CZ RUS RO
CAUTION
The impact drill is not designed for reverse
hammering. Failure to obey this caution may
result in property damage.
PL SLO HR TR