Technical Data; Noise/Vibration Information; Declaration Of Conformity - Bosch gsb 1600 re Professional Originalbetriebsanleitung

Technical Data

Impact Drill
Article number
Rated power input
Output power
No-load speed
Rated speed
Impact rate
Rated torque
Speed preselection
Right/left rotation
Spindle collar dia.
Max. drilling dia.
– Brickwork
– Concrete
– Steel
– Wood
Chuck clamping range
Weight according to
EPTA-Procedure 01/2003
Protection class
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.

Noise/Vibration Information

Measured values determined according to
EN 60745.
Typically the A-weighted noise levels of the prod-
uct are: Sound pressure level 98 dB(A); Sound
power level 109 dB(A). Uncertainty K =3 dB.
Wear hearing protection!
Bosch Power Tools
GSB 1600 RE
Professional
3 601 B18 1..
W 701
W 351
rpm 0–3000
rpm 1640
bpm 26270
Nm 2.0
mm 43
mm 18
mm 16
mm 12
mm 30
mm 1.5–13
kg 1.9
/ II
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Drilling into metal: Vibration emission value a
2
2.7 m/s , Uncertainty K =1.5 m/s
Impact drilling into concrete: Vibration emission
2
value a = 23 m/s , Uncertainty K =3.5 m/s
h
Screwdriving: Vibration emission value
2
a <2.5 m/s , Uncertainty K =1.5 m/s
h
The vibration emission level given
WARNING
in this information sheet has
been measured in accordance with a standard-
ised test given in EN 60745 and may be used to
compare one tool with another.
The vibration emission level will vary because of
the ways in which a power tool can be used and
may increase above the level given in this infor-
mation sheet. This could lead to a significant un-
derestimate of exposure when the tool is used
regularly in such a way.
Note: To be accurate, an estimation of the level
of exposure to vibration experienced during a giv-
en period of work should also take into account
the times when the tool is switched off and when
it is running but not actually doing the job. This
may significantly reduce the exposure level over
the total working period.

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with the following standards or
standardization documents: EN 60745 according
to the provisions of the directives 2004/108/EC,
98/37/EC (until Dec. 28, 2009), 2006/42/EC
(from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
03.08.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
English | 17
2
,
2
,
2
.
Dr. Eckerhard Strötgen
Head of Product
Certification
1 609 929 M07 | (11.9.07)
=
h