Prefatory Note - Airpress HLO 110/6 Betriebsanleitung

ENGLISH
TABLE OF CONTENTS
1.0 Prefatory note
2.0 Safety instructions
3.0 Placing
3.1 Electric connection
3.2 Air connection
4.0 First use
5.0 Operation
6.0 Maintenance
7.0 Possibilities of failure
8.0 Technical details
LEGENDA Fig. 1 (subject to modification)
A manual pressure switch
B reducing valve setting
C push bow
D coupling reduced pressure receiver
E safety valve
F bonnet for engine and fan
G non return valve
H gauge reduced pressure
I pressure gauge for pressure of air
J drain tap for condensation water
K discharge line
L pressure pipe
ATTENTION
To be able to use this compressor installation properly, a number of measurements
must be taken. The following points will contribute to making you a satisfied user of
this installation.
1.0 PREFATORY NOTES
Buying this compressor installation, you have become the owner of a compressor
installation with a high performance and reliability level. Correct use and regular
maintenance will increase the life of the compressor. n this manual you will find
operation and maintenance instructions. Read it carefully and keep it as a guide to
your compressor.
The compressor has been built to supply compressed air. In particular the appliance
cannot be used to produce air to be breathed by humans or used on direct contact
with foodstuffs. The appliance must be used only for the purpose for which it was
specifically designed. All other uses are to be considered incorrect and therefore
unreasonable. The manufacturer cannot be held responsible for any damage
resulting from improper, incorrect or unreasonable use. This machine is not suitable
for external installation.
page 11
page 12
page 13
page 13
page 14
page 14
page 14
page 14
page 15
page 15
11