Transport; Ordering Spare Parts; Disposal And Recycling - EINHELL BG-CB 2041 T Originalbetriebsanleitung

Note: Store the equipment in a dry place and
far away from possible ignition sources such as
an oven, a gas-fi red hot water boiler, a gas-fi red
dryer, etc.
Putting the equipment back into operation
1. Remove the spark plug (see section 9.5).
2. Quickly tug on the starter cord to remove ex-
cess oil from the combustion chamber.
3. Clean the spark plug and check that the
electrode gap is correct, or insert a new spark
plug with the correct electrode gap.
4. Prepare the equipment for operation.
5. Fill the tank with the relevant mixture of fuel
and oil. See the section „Fuel and oil".

10.3 Transport

To transport the machine, empty the petrol tank
as described in section 10. Clean coarse dirt off
the equipment with a brush or hand brush. Dis-
mantle the drive rod mechanism as described in
section 5.2.

10.4 Ordering spare parts

Please provide the following information on all
orders for spare parts:
•
Model/type of the equipment
•
Article number of the equipment
•
ID number of the equipment
•
Part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info

11. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Defective components must be dispo-
sed of as special waste. Ask your dealer or your
local council.
Anl_BG_BC_2041_T_TH_SPK1.indb 30 Anl_BG_BC_2041_T_TH_SPK1.indb 30
GB
- 30 -
29.10.14 10:11 29.10.14 10:11