Condenser Sponge (For Products Equipped With A Heat Pump); Sensor And Drum Fin - Blomberg TKF 7449 Bedienungsanleitung

7 Close the filter unit as to lock the red
button.
8. Place the filter drawer back into its place
and push forward until a click sound is
heard.
Important:
• Drying without the filter sponge will
damage your machine!
• A dirty heat pump will cause longer drying
periods and higher energy consumption.
• Place the sponge as shown below, without
forcing it. Pay attention to seat the left side
of the sponge into the appropriate housing
in the filter drawer as marked in the picture.
• Do not squeeze the sponge to make it go
into the inner frame as shown in the picture
below.
Condenser sponge (for products
equipped with a heat pump)
It is very important that the lint and fibres are
caught completely by the filters of your machine
which is equipped with a condenser with heat
pump. Failure in functioning of the filters may
cause a drop in the performance or breakdown
of your machine. Therefore, in addition to the
"Cover Filter" and "Filter Drawer" filtering phases
in your machine, there is also a "Condenser
Sponge" piece for protection purpose. If the
"Cover Filter" and "Filter Drawer" are functioning
appropriately, , "the "Condenser Sponge" piece
should be checked every 3 months. Any layer
of accumulated lint on the sponge must be
removed.
C
If the lint and fibre collected on the sponge
is sparse and small, you do not have to
clean the sponge.
To clean the condenser sponge;
1 Take out the condenser sponge from its
place.
C
You can reach the condenser filter after
taking out the filter drawer.
C
Condenser can be seen after taking out the
condenser sponge.
2 Clean the sponge and place it properly
back into its place. Place the sponge in
its housing between the condenser and
plastic frame.
Important:
• When placing the condenser sponge, make
sure that some part or whole of the sponge
does not run over the plastic frame.
Misplacing will lead unsatisfactory filtering
and may cause a drop in the performance
of or damage to your machine.
C
A spare "Filter Drawer Sponge" and a
spare "Condenser Sponge" piece are
supplied together with the machine. You
must be careful not the lose these spare
parts.

Sensor and drum fin

There are humidity sensors in your machine that
detect whether the laundry is dry or not.
19 - EN