Atag HI6071F Anleitung Seite 110

INSTALLATION INSTRUCTIONS
5. Remove the protective layer from the sealing tape and apply
the tape in the groove of the aluminium profile or on the
edge of the glass plate. Do not stick tape round the corners,
but cut 4 separate pieces to seal the corners well.
6. Turn the hob over and lay it in the recess.
7. Connect the appliance to the mains. A short bleep will be
heard and all the displays will light up briefly. The appliance
is ready for use.
8. If the hob is integrated, seal the joint.
9. Check that it works properly. If the appliance has been
wrongly connected either a tone will sound or a fault code
will appear in the displays, depending on the error.
10. Hand the instructions for use to the client or keep the
manual yourself.
As soon as the hob is switched on the fan will run briefly and
the appliance will test itself for a few seconds.
GB 27
building in