Pelgrim GVW552RVS Benutzerinformation Seite 70

70
and mmol/l (millimol per litre - international
unit for the hardness of water).
The softener should be adjusted according
to the hardness of the water in your area.
Your local Water Authority can advise you on
the hardness of the water in your area.
Water hardness
°dH
51 - 70 91 - 125
43 - 50
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
Setting manually
The dishwasher is factory set at position
2.
1. Open the dishwasher door.
2. Remove the lower basket from the dish-
washer.
3. Turn the water hardness dial to position
1 or 2 (see chart).
4. Replace the lower basket.
Setting electronically
The dishwasher is factory set at level 5.
1. Press the on/off button. The appliance
must be in setting mode.
2. Press and keep pressed the programme
selection/cancel button until programme
light A flashes and programme light B
comes on with a fixed light. Wait until pro-
gramme light B goes off. The programme
light A goes on flashing and simultane-
°TH mmol/l
9,1 - 12,5
76 - 90 7,6 - 9,0
65 - 75 6,5 - 7,5
51 - 64 5,1 - 6,4
40 - 50 4,0 - 5,0
33 - 39 3,3 - 3,9
26 - 32 2,6 - 3,2
19 - 25 1,9 - 2,5
7 - 18 0,7 - 1,8
< 7 < 0,7
The water softener must be set in two
ways: manually, using the water hard-
ness dial and electronically.
Adjusting the water hardness setting
manually
2
2
2
2
2
2
1
1
1
1
ously the end of programme indicator
light starts flashing. Wait until programme
light B goes off. The programme light A
goes on flashing and simultaneously the
end of programme indicator light starts
flashing. This indicates that you have ac-
tivated the electronic setting function of
the water softener. The current level is in-
dicated by the number of flashes of the
end of programme indicator light and a
pause of a few seconds.
Examples:
5 flashes, pause, 5 flashes, pause, etc. =
level 5
6 flashes, pause, 6 flashes, pause, etc. =
level 6
3. To change the level, press the pro-
gramme selection/cancel button. Each
time the button is pressed the level
changes. (For the selection of the new
level see the chart).
Examples:
if the current level is 5, by pressing pro-
gramme selection/cancel button once,
level 6 is selected,
if the current level is 10, by pressing pro-
gramme selection/cancel button once,
level 1 is selected.
4. To memorize the operation, switch off the
dishwasher by pressing the on/off button.
Use of
electronically
level 10
level 9
level 8
level 7
level 6
level 5
level 4
level 3
level 2
level 1
salt
yes
yes
yes
yes
yes
yes
yes
yes
yes
no