Philips Avent SCF870/21 Bedienungsanleitung Seite 14

ENGLISH
16
Problem Possible cause
The appliance The appliance is
does not work. equipped with a safety
lock. If the parts have
not been assembled
properly onto the
motor unit, the
appliance does not
work.
The steaming light The appliance is not
does not go on. connected to the
mains.
The jar is not placed
on the motor unit
properly.
You want to start a
second steaming
process just after one
has finished.
The ingredients The pieces in the jar
are not heated up are too big, there is
completely. too much food in the
jar or you have not
steamed the food long
enough.
The appliance You have not put
does not steam. water in the appliance.
You have not put the
jar on the motor unit
in the correct position.
Steaming takes There is too much
too long or the scale in the water
steam function tank.
does not work at
all.
Steam is coming The lid of the filling
out of the filling opening is not closed
opening. properly.
The steam outlet on
the motor unit is
blocked by food or by
scale.
The steam hole in the
lid is blocked.
Solution
Assemble all parts properly. See chapter
'Using the appliance'.
Put the plug in the wall socket.
Place the jar on the motor unit properly.
Switch off the appliance and let it cool down for a
few minutes before you start a second steaming
process.
Cut the food into smaller pieces (2-3cm), decrease
the amount of food in the jar or select a longer
steaming time (max. 20 minutes). Check the recipe
booklet and/or the table in chapter 'Ingredients and
steaming times' to make sure that you select the
correct steaming time for the ingredients you want
to steam or the recipe you want to prepare.
Switch off the appliance and put the right amount
of water in the appliance.
Place the jar on the appliance in the correct
position (see section 'Steaming' in chapter 'Using the
appliance').
Descale the water tank. See chapter 'Cleaning and
maintenance', section 'Descaling'.
Close the lid of the filling opening properly ('click').
Clean the steam outlet with a pointy object without
damaging the seal and follow the descaling
instructions in the future. See chapter 'Cleaning and
maintenance, ' section 'Descaling'.
Remove the valve and clean the steam hole in the
lid properly.