Philips Avent SCF870/21 Bedienungsanleitung Seite 10

ENGLISH
12
8 Under normal conditions, no water remains in the water tank after steaming. However,
in some situations (e.g. in case of scale build-up inside the water tank, interruption of the
steaming process or unintended use), some water could remain in the water tank. In this
case, empty the water tank completely after use to avoid bacterial growth. To descale the
water tank, see chapter 'Cleaning and maintenance'.
Blending without steaming
The appliance is intended for:
- pureeing steamed and cooked ingredients for baby food
- blending fluids and fruits for baby drinks
The appliance is not intended for chopping hard ingredients such as ice cubes and sugar cubes.
After you have put liquids in the jar, never put the jar in the steaming position.
Note: When you blend fluids, make sure you do not fill the jar beyond the maximum level indication
on the jar.
Note: Never steam baby food after you have blended it.
1 Put the blade unit on the blade unit holder in the jar (Fig. 5).
2 Cut solid ingredients into small pieces (cubes not bigger than 2-3cm) before you put them in
the jar.
Tip: Do not process a large quantity of solid ingredients at the same time. Process these ingredients in a
series of small batches instead.
3 Put the ingredients in the jar. (Fig. 6)
Note: Do not exceed the top edge of the green blade unit.
4 Put the valve in the lid (Fig. 7).
Note: Make sure the valve is fixed properly.
5 Put the sieve in the lid of the jar ('click') (Fig. 8).
6 Place the lid on the jar and turn it clockwise to fix it. The small projections on the lid have to
slide into the grooves in the jar. Make sure that the large projection of the lid is placed
exactly over the handle of the jar. (Fig. 9)
7 Place the jar upright on the motor unit, i.e. with the lid upwards. Make sure the handle is on
the right-hand side and positioned between the two ridges of the locking area (Fig. 16).
8 Turn the control knob to the blending position. Hold the knob in this position for as long as
you need but for not more than 30 seconds (Fig. 17).
Note: If the ingredients stick to the wall of the jar, switch off the appliance and loosen them with the
spatula or add some liquid. Do not exceed the maximum level indication on the jar.
Note: Make sure that the blended baby food has the right consistency (e.g. no lumps) before you serve it.
Note: If the baby food is still too solid, add some fluid (e.g. water) until the baby food is soft and smooth.
Do not exceed the maximum level indication on the jar.
Note: Never steam baby food after you have blended it.
Do not let the appliance blend for more than 30 seconds at a time. If you have not finished
blending after 30 seconds, switch off the appliance and wait a few seconds before you continue.
If the motor unit becomes hot, let it cool down for a few minutes before you continue.