SKYTRONIC 4CH Gebrauchsanleitung Seite 19

SMTP Port: indicates sender port of SMTP server. Generally the SMTP port value is 25, but there
are exceptions, for example, SMTP port of G-mail server should be 465.
SMTP server: indicates server address you use.
Sender email: indicates sender's email address. The email address should be consistent with the server
you use. That is to say, when you use email address – aaa@gmail.com, the according server should be
smtp.gmail.com.
Receiver address: indicates receiver's email address. The email address is used to receive image t
ransmitted from motion detection alarm of DVR. Please clear the images you have received as
soon as possible to avoid overloading your email account. For detailed SMTP protocols settings
refer to the below picture 5-35A.
5.2.6.3 PTZ Setup
Picture 5-36
5.2.6.4 Mobile
Picture 5-37
Picture 5 35A
Enter into [Main menu Device
the channel you want to control and set PTZ protocol
(Pelco-D or Pelco-P), Baud Rate (1200, 2400, 4800, 9600),
Stop bit (1, 2), Parity Check (None, Odd, Even Mark Space),
Address Code and Cruise status respectively. Please note
the above mentioned channel settings must match the
settings of the PTZ camera.
Click [Main menu Device Mobile] to enter into [Mobile]
menu.
User Name: indicate user name of DVR.
User password: indicate user password of DVR
Server port: Mobile monitoring port. Setting range is between
1024 and 65535. Please note that
Explanation: Please connect DVR to Internet before
setting DVR port number and the server port no is not equal to
network menus.
PTZ Setup] to select