Correcting The Date And Time; (Lite Touch Zoom 150Ed Qd Only) - Nikon Lite Touch Zoom 150ED Bedienungsanleitung

Correcting the date and time

(Lite Touch Zoom 150ED QD only)

MODE/SEL button
ADJ button
1 Press and hold the MODE/SEL button for more
than 2 seconds.
When the date/time display format is Year/Month/Day, Month/Day/Year,
or Day/Month/Year, "Year" indicator flashes first. For Day/Hour/Minute
display, "Hour" indicator flashes first.
The date/time correction can be performed with the camera either on or
off. When the camera is on, the data will be immediately registered if the
slide cover is closed, or the Mid-roll Rewind button or a Zoom button is
pressed while the setting is in progress.
2 Press the ADJ button to set the flashing digit.
Each time you press the ADJ button, the number advances by one.
Holding the ADJ button pressed for more than 2 seconds advances the
number quickly.
3 When the flashing indicator is correctly set,
press the MODE/SEL button again so that the
next indicator flashes.
Repeat steps 2 and 3 to set all the digits. When the Year/Month/Day or
Day/Hour/Minute have been adjusted, press the MODE/SEL button to
finish the adjustment procedure. If the Year/Month/Day or Day/Hour/
Minute are all displayed correctly, adjustments has been completed.
When the battery is replaced
aThe LCD panel shows "
aThe date/time is not imprinted in pictures taken while "
indicated. Set the date and time following the above procedure.
aIf the battery is replaced immediately, the date and time previously set
remain in memory and you do not need to set again.
".
Additional Information
En
" is
41