Correcting The Date And Time (Lite Touch Zoom 100W Qd Only) - Nikon Lite Touch Zoom 100W Bedienungsanleitung

Correcting the date and time
(Lite Touch Zoom 100W QD only)
1
2
3
a"
aThe date/time is not imprinted in pictures taken while "
Downloaded from www.Manualslib.com
Press and hold the MODE/SEL button for more
than 2 seconds.
When the date/time display format is Year/Month/Day, Month/Day/
Year, or Day/Month/Year, the display in correction mode turns into
Year/Month/Day, and then "Year" indicator blinks first. For Day/Hour/
Minute display, "Hour" indicator blinks first.
When the camera is on, the data will be immediately registered if the
slide cover is closed, or the Mid-roll Rewind button or a Zoom button
is pressed while the setting is in progress.
Press the ADJ button to set the blinking digit.
Each time you press the ADJ button, the number advances by one.
Holding the ADJ button pressed for more than 2 seconds advances the
number quickly.
When the blinking indicator is correctly set,
press the MODE/SEL button again so that the
next indicator blinks.
Repeat steps 2 and 3 to set all the digits. When the Year/Month/Day or
Day/Hour/Minute have been adjusted, press the MODE/SEL button to
finish the adjustment procedure. If the Year/Month/Day or Day/Hour/
Minute are all displayed correctly, adjustments has been completed.
When the battery is replaced
" may be displayed on the LCD panel.
indicated. Set the date and time following the above procedure.
manuals search engine
MODE/SEL button
ADJ button
Additional Information
En
" is
39