Prior To Inital Start-Up; Control Panel; Starting Up And Temperature Regulation - AEG Electrolux SANTO 60276 KG Benutzerinformation

Prior to Initial Start–Up
• Please clean the appliance interior and all accessories prior to initial start-
up (see section: "Cleaning and Care").

Control panel

The thermostat knob (D) is the switch.
The green pilot lamp (C), which comes on when the panel is switched
on and the mains voltage is available. In this switch position, the refri-
gerating unit automatically operates by system control.
Temperature adjustment with ambient temperature below +16°C
When the ambient temperature in the room in which the appliance is situa-
ted is less than 16° C, the ambient switch (B) must be depressed. The yellow
pilot light (A) comes on. In this way, when the ambient temperature is low,
the compressor operates for longer periods to ensure that the storage tem-
perature of -18° C is maintained inside the freezer compartment.
Important!
If the ambient temperature rises to above +16°C, de-activate the ambient
switch in order to avoid unnecessary energy consumption. The yellow pilot
light goes out.

Starting up and temperature regulation

• Insert the plug of the connection lead into the plug socket with protecti-
ve earth contact.
Setting „0" means: Off.
Setting „1" means: Hightest temperature, (warmest setting).
Setting „4" (end-stop) means: Lowest temperature, (coldest setting).
However, the exact setting should be chosen keeping in the mind that the
temperature inside the refrigerator depends on:
30
A B C D