Electrical Connection - AEG Electrolux SANTO 60276 KG Benutzerinformation

11. Refit ventilation grille (D), clipping it
into place.
12. Unscrew the handle. Refit it on
opposite side after having pierced
the plugs with a punch. Cover the
holes left open with the plugs con-
tained in the documentation pack.
Attention:
After having reversed the opening
direction of the doors check that all
the screws are properly tightened
and that the magnetic seal adheres
to the cabinet. If the ambient tempe-
rature is cold (i.e. in Winter), the
gasket may not fit perfectly to the
cabinet. in that case, wait for the
natural fitting of the gasket or acce-
lerate this process by heating up the
part involved with a normal hairdrier.

Electrical connection

Before initial start-up, refer to the appliance rating plate to ascertain if sup-
ply voltage and current values correspond with those of the mains at the
installation location.
e.g.:
(i.e. 230 to 240 volts alternating current, 50 Hertz)
The rating plate is inside the appliance on the left.
A correctly installed, earthed socket is required for the electrical supply. The
supply must have a fuse rating of at least 10 Amps.
If the socket is not accessible once the appliance is built in, the electrical
installation must include suitable means of isolating the appliance from the
mains (e.g. fuse, cut-out, current trip or similar with a minimum contact
separation of 3 mm).
Attention: The mains connection cable may only be replaced by a skilled
electrician. Please contact your dealer or our customer service department
for repairs.
AC 230 ... 240 V
230 ... 240 V~
D162/a
50 Hz
50 Hz or
G
29