Inner Door Reversal; Electrical Connection; Prior To Initial Start-Up - AEG Electrolux S74270KA8 Benutzerinformation

Inner door reversal

1. Using a screwdriver release
bracket (1) by pressing on the
internal spring and withdraw it
from its seat together with the
door; remove plug (2) and fit it in
the hole left open on the opposi-
te side; turn the door through
180°, remove the bracket (1) and
refit it on the opposite side.
2. Refit the door and insert the top pin and bottom bracket (1), pushing it into
place.
To ensure correct storage of food, the door is fitted with a simple spring
device which holds it in the open position until it is properly closed.

Electrical connection

Before initial start-up, refer to the appliance rating plate to ascertain if sup-
ply voltage and current values correspond with those of the mains at the
installation location.
e.g.:
(i.e. 220 to 240 volts alternating current, 50 Hertz)
The rating plate is inside the appliance on the left.
A correctly installed, earthed socket is required for the electrical supply. The
supply must have a fuse rating of at least 10 Amps.
If the socket is not accessible once the appliance is built in, the electrical
installation must include suitable means of isolating the appliance from the
mains (e.g. fuse, cut-out, current trip or similar with a minimum contact
separation of 3 mm).
Attention: The mains connection cable may only be replaced by a skilled
electrician. Please contact your dealer or our customer service department
for repairs.
Prior to Initial Start–Up
• Please clean the appliance interior and all accessories prior to initial start-
up (see section: "Cleaning and Care").
28
AC 220 ... 240 V
220 ... 240 V~
180°
PR14
50 Hz
2
50 Hz or
1