Closing The Door; Technical Data; Installation - Zanussi ZRB632FW Benutzerhandbuch

1

Technical data

Dimension
Rising Time
The technical information are situated in the rating plate
on the internal left side of the appliance and in the ener-
gy label.

Installation

Caution! Read the "Safety Information" carefully
for your safety and correct operation of the
appliance before installing the appliance.
Positioning
Install this appliance at a location where the ambient tem-
perature corresponds to the climate class indicated on
the rating plate of the appliance:
Climate
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Location
The appliance should be installed well away from sour-
ces of heat such as radiators, boilers, direct sunlight
etc. Ensure that air can circulate freely around the back
of the cabinet. To ensure best performance, if the appli-
30
2
Height 1750 mm
Width 595 mm
Depth 648 mm
16 h
Ambient temperature

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Con-
tact the Service Center.
ZRB632FW
1850 mm
595 mm
648 mm
18 h
ance is positioned below an overhanging wall unit, the
minimum distance between the top of the cabinet and
the wall unit must be at least 100 mm . Ideally, howev-
er, the appliance should not be positioned below over-
hanging wall units. Accurate levelling is ensured by one
or more adjustable feet at the base of the cabinet.
Warning! It must be possible to disconnect the
appliance from the mains power supply; the plug
must therefore be easily accessible after installation.
B
A
ZRB634FW ZRB638FW
2010 mm
595 mm
648 mm
18 h