Movable Shelves; Positioning The Door Shelves; Helpful Hints And Tips; Normal Operating Sounds - Zanussi ZRB632FW Benutzerhandbuch

Thawing
Deep-frozen or frozen food, prior to being used, can be
thawed in the refrigerator compartment or at room tem-
perature, depending on the time available for this opera-
tion.
Small pieces may even be cooked still frozen, directly
from the freezer: in this case, cooking will take longer.

Movable shelves

The walls of the refrigera-
tor are equipped with a
series of runners so that
the shelves can be posi-
tioned as desired.

Positioning the door shelves

To permit storage of food
packages of various
sizes, the door shelves
can be placed at different
heights.

Helpful hints and tips

Normal Operating Sounds

• You may hear a faint gurgling and a bubbling sound
when the refrigerant is pumped through the coils or
tubing. This is correct.
• When the compressor is on, the refrigerant is being
pumped around and you will hear a whirring sound
and a pulsating noise from the compressor. This is
correct.
• The thermic dilatation might cause a sudden crack-
ing noise. It is natural, not dangerous physical phe-
nomenon. This is correct.
26
Gradually pull the shelf in
the direction of the ar-
rows until it comes free,
then reposition as re-
quired.
Removal of freezing baskets from the freezer
The freezing baskets have a limit stop to prevent their
accidental removal or falling out. At the time of its re-
moval from the freezer, pull the basket towards yourself
and, upon reaching the end point, remove the basket by
tilting its front upwards.
At the time of putting it back, slightly lift the front of the
basket to insert it into the freezer. Once you are over the
end points, push the baskets back in their position.
• When the compressor switches on or switches off,
you will hear a faint "click" of the temperature regula-
tor. This is correct.
Hints for energy saving
• Do not open the door frequently or leave it open lon-
ger than absolutely necessary.
• If the ambient temperature is high and the Tempera-
ture Regulator is set to low temperature and the appli-
ance is fully loaded, the compressor may run contin-
uously, causing frost or ice on the evaporator. If this
happens, set the Temperature Regulator toward warm-
2
1