Closing The Door; Technical Data; Installation - Zanussi ZRT724W Benutzerhandbuch

1. Remove the screw
from the lamp cov-
er.
2. Remove the lamp
cover (refer to the
illustration).
3. Replace the used
lamp with a new
lamp of the same
power and specifically designed for household ap-
pliances (the maximum power is shown on the
lamp cover).

Technical data

Dimension
Rising Time
The technical information are situated in the rating plate
on the internal left side of the appliance and in the ener-
gy label.

Installation

Caution! Read the "Safety Information" carefully
for your safety and correct operation of the
appliance before installing the appliance.
Positioning
This appliance can be installed in a dry, well ventilated
indoor (garage or cellar) also, but for optimum perform-
ance install this appliance at a location where the ambi-
ent temperature corresponds to the climate class indica-
ted on the rating plate of the appliance:
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door. Make sure that the light comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Con-
Height
Width
Depth
Climate
SN
N
ST
T
Rear spacers
In the bag with the documentation, there are two
spacers which must be fitted as shown in the figure.
tact the Service Center.
1404 mm
545 mm
604 mm
19 h
Ambient temperature
class
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
45