Using The Remote Control; Loading A Cd/Dvd; Playing Media - AEG dvd 4536 Bedienungsanleitung

Using the remote control

Loading a CD/DVD

Understanding the
onscreen CD-menu
05-DVD 4536 N AEG_GB.indd 47 05-DVD 4536 N AEG_GB.indd 47
NOTE:
It is not possible to guarantee full compatibility with all of the com-
pression methods used worldwide, particularly when more than one
soundtrack or subtitles are involved. Also MPEG 4 fi les with integrated
special functions such as a menu, subtitles etc. are not always sup-
ported. This is no malfunction of the player.

Playing media

You transmit commands to the DVD-Player via remote control. It is thus
important to point the end of the remote control towards the DVD-
Player.
1. Press the remote control button OPEN/CLOSE (Fig. 3/1). The CD/DVD
tray opens.
2. Place the CD/DVD on the tray.
3. Press the remote control button OPEN/CLOSE (Fig. 3/1) again. The
CD/DVD tray closes. The display (Fig. 1/11) fi rst shows „LOAd". After a
short while the type of the loaded medium is displayed (e.g. „DVD").
When playing CDs the following status information is displayed on screen:
Media type (1), e.g. "CD".
Current track/total number of tracks (2).
Audio output (3): If the MUTE-button (Fig. 3/37) on the remote
control was pressed, the audio output is prevented. The word „Mute"
appears on the screen.
Repeat (4):
„x": no repeat.
„1": the current track is repeated.
„A": all tracks are repeated.
Specify the repeat with the REPEAT-button.
Time (5): This provides information about the duration and the re-
maining play time. By standard the play time expired of the current
track is displayed. The display is in hours, minutes and seconds. Press
the DISPLAY button (Fig. 3/4) once or several times to have further
times displayed.
The following possibilities are available for selection
time remaining to the end of the track,
expired playing time of the CD,
time remaining to the end of the CD.
English
47
30.07.2009 16:50:19 Uhr 30.07.2009 16:50:19 Uhr