Playing Media; Using The Remote Control; Loading A Cd/Dvd - AEG dvd 4532 usb Bedienungsanleitung

Terminology

Using the remote control

Loading a CD/DVD

05-DVD 4532 USB-CR_GB.indd 45 05-DVD 4532 USB-CR_GB.indd 45
NOTE:
With your DVD-Player you can only play DVDs with regional code "2".
There are both lots of burning and compressing methods as well as high
quality diff erences in (burned) CDs/DVDs. Moreover, the music industry
has not yet agreed on a fi xed standard for copy protection. This may,
in very isolated cases, result in problems when relaying CDs, DVDs and
MP3 CDs. This is no malfunction of the player.
Furthermore, there may be isolated problems when playing CDs or DVDs
which were created on a PC (e.g. holiday photographs). In case of pro-
blems check the settings of the DVD writing program on your computer.
You should in particular make sure that the DVD has been fi nalized. For
further information on this matter please refer to the operating manual
of your recorder.
Input Not Possible
If a function or input selected by you is not possible, the adjacent symbol
is shown on the screen.
Track: "Track" is the designation for sections on an Audio-CD. This
may be a song, the set of a symphony, etc.
Title/Chapter: Video-DVDs are divided into "Title" and „Chapters". A
„Title" may be e.g. a particular fi lm, the „Chapters" may be subsections
of this fi lm.
MPEG4:Your DVD player is also suitable for playing back fi les that
have been compressed using the MPEG-4 system (short for Moving
Picture Experts Group-4). MPEG-4 is a compression method by means
of which large quantities of data can be reduced without any notice-
able loss of picture and sound quality.

Playing media

You transmit commands to the DVD-Player via remote control. It is thus
important to point the end of the remote control towards the DVD-Player.
NOTE: Important!
If you have previously displayed the data of a USB device or memory
card, please remove these as otherwise the CD/DVD cannot be read.
1. Press the remote control button OPEN/CLOSE (Fig. 3/1). The CD/DVD
tray opens.
2. Place the CD/DVD on the tray.
3. Press the remote control button OPEN/CLOSE (Fig. 3/1) again. The
CD/DVD tray closes. The display (Fig. 1/3) fi rst shows „LOAd". After a
short while the type of the loaded medium is displayed (e.g. „DVD").
English
45
21.02.2008 11:15:54 Uhr 21.02.2008 11:15:54 Uhr