Connecting The Units; Power Cable Connection - Pioneer DVH-P5900MP Bedienungsanleitung

Connecting the Units

Power cable connection

Note:
Depending on the kind of vehicle, the
function of 3* and 5* may be different. In
this case, be sure to connect 2* to 5* and 4*
to 3*.
3*
5*
Cap (1*)
Do not remove cap if
this terminal is not in
use.
ISO connector
Note:
In some vehicles, the ISO connector
may be divided into two. In this case,
be sure to connect to both connectors.
When you connect the separately sold multi-channel
processor (DEQ-P6600) to this unit, do not connect
anything to the speaker leads and system remote
control (blue/white).
3
1*
2*
4*
Yellow (3*) Yellow (2*)
Back-up (or Connect to the constant
accessory) 12 V supply terminal.
Red (5*) Red (4*)
Accessory Connect to terminal controlled
(or back-up) by ignition switch (12 V DC).
Black (chassis ground)
Connect to a clean, paint-free metal location.
Antenna jack
Connect leads of the same
color to each other.
Fuse (10 A)
Speaker leads
White: Front left
White/black: Front left
Gray: Front right
Gray/black: Front right
Green: Rear left
Green/black: Rear left
Violet: Rear right
Violet/black: Rear right
15 cm
Fuse resistor
or subwoofer
or subwoofer
or subwoofer
or subwoofer