Front Image Enhancer (Fie); Adjusting Source Levels - Pioneer DEH-3400R Bedienungsanleitung

Audio Adjustments
on or off with 5/∞.
2 Select
LOUD
3 Select the desired level with 2/3.
—
LOW (low) MID (mid)
Note
• You can also switch
LOUD
ing the .
LOUDNESS

Front image enhancer (FIE)

The F.I.E. (Front Image Enhancer) function is a
simple method of enhancing front imaging by
cutting mid- and high-range frequency output
from the rear speakers, limiting their output to
low-range frequencies. You can select the fre-
quency you want to cut.
Precaution
• When the F.I.E. function is deactivated, the
rear speakers output sound of all frequencies,
not just bass sounds. Reduce the volume
before disengaging F.I.E. to prevent a sudden
increase in volume.
1 Press to select
AUDIO
Press until appears in the display.
AUDIO FIE
on or off with 5/∞.
2 Select
FIE
3 Select the desired frequency with 2/3.
— —
100 160 250 (Hz)
Notes
• After switching the F.I.E. function ON, select
the Fader/Balance mode in the Audio Menu,
and adjust front and rear speaker volume
levels until they are balanced.
• Switch the F.I.E. function OFF when using a 2-
speaker system.
—
HI (high)
on or off by press-
.
FIE

Adjusting source levels

SLA (Source level adjustment) lets you adjust
the volume level of each source to prevent radi-
cal changes in volume when switching between
sources.
• Settings are based on the volume level of the
FM tuner, which remains unchanged.
1 Compare the FM tuner volume level with
the level of the source you wish to adjust.
2 Press to select
AUDIO
Press until
AUDIO SLA
3 Press 5 or ∞ to adjust the source volume.
Each press of 5 or ∞ increases or decreases
the source volume.
• – is displayed as the source
SLA +4 SLA –4
volume is increased or decreased.
Notes
• Since the FM tuner volume is the control, it is
not possible to apply source level adjustments
to the FM tuner.
• The MW/LW tuner volume level can also be
adjusted with source level adjustments.
.
SLA
appears in the display.
En
16