Calling The Wake-Up Timer; Cancelling The Wake-Up Timer; Using The Wake-Up Timer; Using The Sleep Timer - Pioneer X-HM11-K Bedienungsanleitung

04 Getting started

Calling the wake-up timer

An existing timer setting can be reused.
1 Follow steps 1 to 3 in "Setting the wake-up
timer".
Press HI to select "TIMER ON", then press
2
ENTER.

Cancelling the wake-up timer

Turn off the timer setting.
1 Follow steps 1 to 3 in "Setting the wake-up
timer".
Press HI to select "TIMER OFF", then
2
press ENTER.

Using the wake-up timer

Press 1 STANDBY/ON to turn the power
1
off.
2 At the wake-up time, this unit will turn on
automatically and play the selected input
function.
Note
• If at the wake-up time an iPod/iPhone/iPad is not
connected to the unit or a disc is not inserted, the unit
will be turned on but will not play back the track.
• Some discs may not be played automatically at the wake-
up time.
• When setting the timer set at least one minute between
the start and end time.

Using the sleep timer

The sleep timer switches off the unit after a specified time so
you can fall asleep without worrying about it.
1 Press SLEEP repeatedly to select a switch off
time.
Choose between 10 min, 20 min, 30 min, 60 min, 90 min, 120
min, 150 min, 180 min or OFF. The newly set value displays for
3 seconds, and then the setting is completed.
Note
• The sleep timer can be set by pressing SLEEP while the
remaining time is displayed.
14
En

Using Headphones

Insert the headphone's jack plug into the connector.
When the headphones are connected, there is no sound
output from the speakers.
 STANDBY/ON
TIMER
INPUT
PHONES AUDIO IN
• Do not turn the volume on to full at switch on and listen
to music at moderate levels. Excessive sound pressure
from earphones and headphones can cause hearing
loss.
• Before plugging in or unplugging the headphone,
reduce the volume.
• Be sure your headphone has a 3.5 mm diameter plug
and impedance between 16
recommended impedance is 32
• Audio from the iPod/iPhone/iPad cannot be heard via
the headphones connected to the unit. "HP MUTE" will
be displayed if you connect the headphones when the
iPod/iPhone/iPad function is selected.
VOLUME
    
X-HM21
: :
and 50 . The
:
.