Closing The Door; Technical Data; Installation; Positioning - AEG ARCTIS G 9 88 50-5I Benutzerhandbuch

Problem

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Force Center.

Technical data

Dimension of the recess
Rising Time
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.

Installation

Positioning

WARNING!
If you are discarding an old appliance that has a lock or catch on the door, you must ensure
that it is made unusable to prevent young children being trapped inside.
The appliance shall have the plug accessible after installation.
Install this appliance at a location where the ambient temperature corresponds to the
climate class indicated on the rating plate of the appliance:
Climate class
SN
N
ST
T

Electrical connection

Before plugging in, ensure that the voltage and frequency shown on the rating plate cor-
respond to your domestic power supply.
Possible cause
The temperature regulator is not
set correctly.
Height
Width
Depth
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
Set a higher temperature.
880 mm
560 mm
550 mm
26 h
Ambient temperature
25
Technical data
Solution