Setting Down, Transportation And Storage; Maintenance - Miele HS15 Gebrauchsanweisung

en

The Standby button is designed
to pause the vacuum cleaner for
short periods of time whilst vacuum-
ing. Do not leave the vacuum cleaner
in Standby mode for long periods.
Otherwise there is a risk of overheat-
ing and damage.
An LED will indicate each time a button
is pressed on the handle.
At the end of the pause you can do one
of the following:
 Press the Standby button  again to
switch the vacuum cleaner back on at
the setting you were using before
pausing it.
 Press the + button to switch the va-
cuum cleaner back on using the
highest power setting.
 Press the - button to switch the va-
cuum cleaner back on using the low-
est power setting.
Setting down, transportation
and storage
Park System for pauses during vacu-
uming (dia. 29)
The Park System allows you to conveni-
ently park the suction tube and floor-
head during pauses.
 Slot the floorhead or floorbrush into
the parking attachment on the va-
cuum cleaner.
If your vacuum cleaner is on a slop-
ing surface, e.g. a ramp, retract the
telescopic tube fully.
48
Park system On/Off switch
Some models are fitted with an On/Off
switch in the Park system.
The vacuum cleaner switches off auto-
matically when the floorhead or floor-
brush is slotted into the parking attach-
ment. When it is removed from the
parking attachment, the vacuum
cleaner switches back on at the previ-
ously selected power level.
Park system for storage (dia. 30)

Always disconnect the vacuum
cleaner from the electrical supply
when you have finished using it.
Switch it off at the wall socket and
unplug it.
 Stand the vacuum cleaner upright.
Retract the telescopic tube fully so
that the vacuum cleaner takes up less
room for storage.
 Slot the floorhead downwards into
one of the parking attachments on
the side of the vacuum cleaner.
This makes the vacuum cleaner easier
to carry or store.

Maintenance


Always disconnect the vacuum
cleaner from the electrical supply for
maintenance work and for cleaning.
Switch off at the wall socket and un-
plug it.
The Miele filtration system consists of
three components:
– Dustbag