Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Aerial connection
Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS socket and position the FM aerial
wire in the direction where the strongest signal can be received.
Supplied AM loop aerial:
Connect the AM loop aerial wire to the AM and GND terminals. Position the AM loop
aerial for optimum reception. Place the AM loop aerial on a shelf, etc., or attach it to
a stand or wall with screws (not supplied).
White
Black
Note:
Keep the FM/AM aerial away from the amplifier unit, MD/CD/tuner unit, AC power
lead, and speaker lead. If they are too close, the noise may be heard.
Installing the AM loop aerial:
< Assembling >
Wall
Speaker connection
Connect the speaker wire (not supplied) to SPEAKERS terminals.
Caution:
Connect the speaker wires to the speakers first, then to the unit.
Use a speaker system which has 50 W or more rated power input and 4 ohms
impedance.
If the volume is turned up too high with the speakers of less than 4 ohms imped-
ance connected, the protection circuit of the amplifier activates. Nothing is heard
temporarily.
Do not mistake the right and the left channels. The right speaker is the one on the
right side when you face the unit.
Do not short-circuit the speaker lead. If it happens with the power on, the
protective circuit is activated and the unit is set to the power stand-by mode.
In this case, check that the speaker lead is connected correctly before turn-
ing on the power again.
< Attaching to the wall >
Screws
Speaker wire
01/5/9
SG11H_E01-14.fm
SD-SG11H
D
F
S
V
I
N
E
E-10
Werbung
Kapitel
Inhaltsverzeichnis
