Transport And Packaging; Appliance Equipment; Installation - BOMANN GS 2196 Bedienungsanleitung

• Use the provided collection points of electrical equipment for the dis-
posal of the appliance.
Coolant Coolant Coolant Coolant
WARNING WAR NING: : : :
WAR WAR NING NING
The coolant circuit of this appliance contains the
refrigerant Isobutane (R600a), a natural gas that is
flammable and of high environmental compatibility.
Make sure no parts of the coolant circuit get dam-
aged during transport and installation of the appli-
ance.
If the coolant circuit is damaged: If the coolant circuit is damaged: If the coolant circuit is damaged: If the coolant circuit is damaged:
• avoid any open flames or ignition source,
• disconnect the plug,
• thoroughly air the room in which the appliance is
installed and
• contact an authorized technician.

Transport and Packaging

Transport
Transport Transport
Transport the appliance Transport the appliance
Transport the appliance Transport the appliance
Transport the appliance, if possible, only in vertical
position. Otherwise, it is absolutely necessary to
allow the appliance standing upright for a few hours
before installation "Prior to first use". Protect the ap-
pliance during transport against weather influences.
Unpack the appliance Unpack the appliance Unpack the appliance Unpack the appliance
• Remove the appliance from its packaging.
• Remove all packaging material, such as foils, filler
and cardboard packaging.
• To prevent hazards, check the appliance for any
transport damage.
• In case of damage, do not put the appliance into
operation. Contact your distributor.
CAUTION: Transport protection! CAUTION: Transport protection!
CAUTION: Transport protection! CAUTION: Transport protection!
Pull off the foil from the appliance sides.
and Packaging
and Packaging and Packaging
NOTE: : : : NOTE
NOTE NOTE
Production residue or dust may have collected on the
appliance. We recommend cleaning the appliance
according to chapter "Cleaning and Maintenance".
Appliance Appliance E E E E quipment
Appliance Appliance
Appliance overview Appliance overview
Appliance overview Appliance overview
1 1 1 1 Temperature control
2 2 2 2 Appliance door
Delivery scope Delivery scope
Delivery scope Delivery scope
3 x freezing drawer, 1 x ice-cube tray, 1 x door han-
dle incl. fixing screws with covers
Condition Conditions for the installat s for the installation location
Condition Condition s for the installat s for the installat
• Good ventilation is required around the appliance,
in order to dissipate the heat properly and to
guarantee efficient cooling operation at low power
consumption. Sufficient clearance is necessary.
Gap to the back and to the side walls each
-
approx. 5 cm;
Place the appliance so that the appliance door
-
can open without being impeded.
• Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
For information on the climate class, please refer
to chapter "Technical Data" or to the rating label
16
quipment
quipment quipment
3 3 3 3 Freezing drawers
4 4 4 4 Adjustable feet

Installation

Installation Installation Installation
ion location
ion location ion location