Cleaning And Maintenance; Troubleshooting - BOMANN GS 2196 Bedienungsanleitung

• Allow warm dishes to cool down before putting
into the appliance.
• Do not adjust the temperature colder than neces-
sary.
• Do not open the door longer than necessary.
• The appliance should be defrosted regularly.
• The seal of the appliance door must be complete-
ly intact, so that the door closes properly.

Cleaning and Maintenance

Cleaning and Maintenance Cleaning and Maintenance Cleaning and Maintenance
WARNING: WARNING:
WARNING: WARNING:
• Always switch off and disconnect the appliance
from the power supply before cleaning and user
maintenance.
• Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of electric shock! Risk Risk Risk of electric shock! Hot steam could damage of electric shock! of electric shock!
the plastic parts.
• The appliance must be dry before restarting oper-
ation.
CAUTION: CAUTION:
CAUTION: CAUTION:
• Do not use a wire brush or other sharp, abrasive
items.
• Do not use any acidic or abrasive detergents.
• Do not damage the refrigerant circuit.
Cleaning the appliance including interior Cleaning the appliance including interior
Cleaning the appliance including interior Cleaning the appliance including interior
• Clean the appliance interior, the exterior surfaces,
the accessories and the door seal regularly with
warm water and mild detergent.
• Remove for that the appliance content and stor-
age at a cool location.
• After everything was thoroughly dried, you can
restart the operation.
Defrosting Defrosting
Defrosting Defrosting
CAUTION: : : : CAUTION CAUTION CAUTION
Never use metal objects (e.g. knifes) to remove ice
from the evaporator. Otherwise it can be damaged.
A defect evaporator can cause serious damage.
To achieve better cooling and to save energy, defrost
the appliance regularly as follows:
• To start the defrosting process, disconnect the
appliance from the power supply.
• Remove the food items and keep covered at a
cool location.
• When the ice has melted, wipe the condensate
away and dry the appliance interior.
• Then you may restart the appliance by connecting
the plug and turning the temperature control.

Troubleshooting

Troubleshooting Troubleshooting Troubleshooting
Before you contact an authorized specialist Before you contact an authorized specialist
Before you contact an authorized specialist Before you contact an authorized specialist
Problem Problem Problem Problem Cause / Action Cause / Action Cause / Action Cause / Action
Appliance is - Insert the power plug correctly or
not working check the fuse.
or not - Check the temperature setting.
properly - Check the ambient temperature.
- Unblock the ventilation openings,
install the appliance freely.
Stored food - Check the temperature setting.
is too warm - Open the door only as long as neces-
sary.
- Check the location.
Loud noise - Check the appliance position.
during oper- - See the section "Operating noise".
ation
Water on the Check the temperature setting.
appliance
bottom
Water on the On days of high humidity, condensation
outer surface might occur on the outer surface of the
appliance. No malfunction!
20