Operation; Cleaning And Maintenance - EuroLite LED IP FL-6 Bedienungsanleitung

OPERATION

These instructions are for all items except for article 51914650, 51914652, 51914542, 51914547:
Adjusting the sensor sensitivity with SENS: The more the control is turned to the right, the more
sensitive is the reaction of the motion detector; i.e. it responds more quickly to slight temperature
changes in the detection area. If you set the sensitivity too high, even small animals or the motion of
leaves (on bushes or trees) may activate the motion detector, unintentionally activating the lamp.
For all items:
Adjusting the illumination duration after detection with TIME: Using this control, you can set the
duration for the luminary's on-time. Turning the control counter clockwise lengthens the on-time, turning
clockwise shortens it. The on-time can be adjusted from 12 seconds to 600 seconds.
Adjusting the brightness sensitivity with DAYLIGHT: With this control knob, the brightness sensitivity can
be set, at which the motion detector is activated. The further the knob is turned clockwise (towards the
„moon" symbol), the later this will be. If the motion detector is to be active while it is still light, turn the
knob anti-clockwise (towards the „sun" symbol).
After you connected the device to the mains, the EUROLITE LED IP FL-Floodlight MD starts running.

CLEANING AND MAINTENANCE

DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by authorized dealers only
in order to avoid hazards.
Should you have further questions, please contact your dealer.
13/14 00071238.DOC, Version 1.1