Bosch PMF 250 CES Originalbetriebsanleitung Seite 16

OBJ_BUCH-1645-003.book Page 16 Monday, March 25, 2013 12:36 PM
16 | English
Selecting the Application Tool/Accessory
The following table shows examples for application tools. Further application tools can be found in the extensive Bosch acces-
sories program.
Accessory
BIM segment saw
blade
Base plate for sand-
ing, series Delta
93 mm
HCS plunge cut saw
blade, wood
HCS plunge cut saw
blades, wood
BIM plunge cut saw
blades, metal
HM-Riff segment
saw blade
HM-Riff delta plate Mortar, concrete remain-
HM-Riff grout and
mortar remover
Scraper, rigid
BIM serrated seg-
ment saw blade
Mounting/Replacing the Application Tool/Accessory
(see figures A –C)
 If required, remove an already mounted application
tool/accessory. For this, push SDS lever 1 out of the lock-
ing position and sidewards.
To release the tool retainer 14, turn the SDS
lever approx. 3 turns in anticlockwise direc-
tion.
2 609 007 124 | (25.3.13)
Material Application
Wooden materials, plas- Separating and plunge cuts; also for sawing close to edges,
tic, non-ferrous metals in corners and hard to reach areas;
example: shortening already installed bottom rails or door
hinges, plunge cuts for adjusting floor panels
Depends on sanding sheet Sanding surfaces close to edges, in corners or hard to reach
areas;
depending on the sanding sheet for, e.g., sanding wood,
paint, varnish, stone
Wooden materials, soft Separating and deep plunge cuts; also for sawing close to
plastics edges, in corners and hard to reach areas;
example: narrow plunge cut in solid wood for installing a
ventilation grid
Wooden materials, soft Smaller separating and plunge cuts;
plastics example: cut-outs in furniture for cable connections
Metal (e.g. unhardened Smaller separating and plunge cuts;
nails, screws, smaller pro- example: shortening narrow profiles, cutting fastening
files), non-ferrous metals elements such as staples
Grouting joints, soft wall Cutting and separating close to edges, in corners or hard to
tiles, glass-fibre reinforces reach areas;
plastic and other abrasive example: removing grouting joints between wall tiles for
materials repair work, cutting openings in tiles, gypsum boards or
plastic
Rasping and sanding on hard surfaces;
ders, wood, abrasive ma- example: removing mortar or tile adhesive (e.g. when
terials replacing damaged tiles)
Mortar, grouting joints, Removing grouting joints from wall and floor tiles as well as
epoxy resin, glass-fibre re- removing mortar and joint adhesive (also in right-angled
inforces plastic and other corners)
abrasive materials
Carpets, coverings Scraping on hard surfaces;
example: removing carpet and tile adhesive
Insulation material, insula- Cutting soft materials
tion panels, floor panels,
sound insulation panels,
cardboard, carpet, rub-
ber, leather
Note: Do not turn the SDS lever 1 further than necessary,
otherwise the tool retainer 14 can fall out of the gear head
(see "Inserting the Tool Retainer", page 17).
 Remove the application tool/accessory.
Bosch Power Tools