Unpacking The Appliance; Appliance Equipment; Installation - BOMANN KB 389 Bedienungsanleitung, Garantie

• Use the provided collection points of electrical equipment for the dis-
posal of the appliance.
Coolant Coolant Coolant Coolant
WARNI NI NI NING WAR NG: : : :
WAR WAR NG NG
The coolant circuit of this appliance contains the
refrigerant Isobutane (R600a), a natural gas that is
flammable and of high environmental compatibility.
Make sure no parts of the coolant circuit get dam-
aged during transport and installation of the appli-
ance.
If the coolant circuit is damaged: If the coolant circuit is damaged: If the coolant circuit is damaged: If the coolant circuit is damaged:
• avoid any open flames or ignition source,
• disconnect the plug,
• thoroughly air the room in which the appliance is
installed and
• contact an authorized technician.

Unpacking the Appliance

Unpacking the Appliance Unpacking the Appliance Unpacking the Appliance
• Remove the appliance from its packaging.
• Remove all packaging material, such as foils, filler
and cardboard packaging.
• To prevent hazards, check the appliance for any
transport damage.
• In case of damage, do not put the appliance into
operation. Contact your distributor.
NOTE NOTE NOTE NOTE: : : :
Production residue or dust may have collected on the
appliance. We recommend cleaning the appliance
according to chapter "Cleaning and Maintenance".

Appliance Equipment

Appliance Equipment Appliance Equipment Appliance Equipment
Appliance overview Appliance overview Appliance overview Appliance overview
1 1 1 1 Ice-cube tray
2 2 2 2 Ice compartment
3 3 3 3 Door storage racks
Delivery scope Delivery scope
Delivery scope Delivery scope
Grid shelf, ice-cube tray, water drip tray
Condition Conditions for the installation location s for the installation location
Condition Condition s for the installation location s for the installation location
• Good ventilation is required around the appliance,
in order to dissipate the heat properly and to
guarantee efficient cooling operation at low power
consumption. Sufficient clearance is necessary.
Gap to the back and to the side walls each
-
approx. 5 cm;
Place the appliance so that the appliance door
-
can open without being impeded.
• Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
For information on the climate class, please refer
to chapter "Technical Data" or to the rating label
located in the interior or on the rear side of the
appliance.
• Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
16
4 4 4 4 Removeable grid shelf
5 5 5 5 Water drip tray

Installation

Installation Installation Installation