BOMANN KB 389 Bedienungsanleitung, Garantie Seite 17

• Avoid the installation: Avoid the installation:
Avoid the installation: Avoid the installation:
near heaters, next to a stove, direct sunlight or
-
any other heat sources;
at locations with high humidity (e.g. outdoors,
-
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
near volatile or flammable materials (e.g. gas,
-
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
Do not expose the appliance any weather.
-
Electrical connection Electrical connection Electrical connection Electrical connection
WARNING: WARNING:
WARNING: WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock! shock shock shock
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
CAUTION: : : : CAUTION
CAUTION CAUTION
In case of disconnection or power failure:
Wait for approx. 5 minutes before restarting.
-
Check the operation settings.
-
• Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reverse the door o Reverse the
Reverse the Reverse the
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING: WARNING:
WARNING: WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE: : : : NOTE
NOTE NOTE
• Ask another person to assist.
You possibly need:
•
driver as well as a thin-blade screwdriver.
electric
electric electric
• Remove the blind cap (1) and the hinge cover (2).
• Dismount the upper door hinge (4) by loosening
the screws (3). Opfen the appliance door a little
and lift it out of the lower door hinge.
• Displace the blind plug (9) of the appliance door
accordingly. Place the appliance door safely
aside.
• Tilt the appliance slightly backwards and block it
in this position. Unscrew the feet (7+8).
• Dismount the lower door hinge (5) by loosening
the screws (6).
• Displace and attach the door hinge (5) at the op-
posite appliance side. Turn in the feet (7+8)
accordingly.
• Replace the appliance upright. Put the appliance
door on the hinge pin and fix it in its intended po-
sition.
• Displace and attach the upper door hinge (4) at
the opposite appliance side.
• Insert in the blind cap (1) at the opposite hole and
put on the hinge cover (2) again, which you have
removed at the beginning.
17
door opening pening
door o door o pening pening
screw wrench, Phillips screw-