Unpacking The Appliance; Scope Of Delivery; Using The Appliance - BOMANN KB 6011 CB N Bedienungsanleitung, Garantie

Unpacking the Appliance

1. Remove the appliance from the package.
2. Remove all packaging material such as films, filler, cable
holders and cardboard.
3. Check the delivery contents for completeness.
4. Should the package contents be incomplete or damages
be found, do not take the appliance into operation. Take
it immediately back to the dealer.
NOTE:
Dust or production residues can be located on the appli-
ance. We recommend to clean the appliance as described
under "Cleaning".

Scope of Delivery

1 Cooler box
1 Power cord for alternating current (AC) 220 – 240 Volt
1 Car power cord for direct current (DC) 12 Volt
Notes for Use
General Notes
• Never place the appliance next to naked flames or other
heat sources.
• For best results, only store already cooled food / bever-
ages in the cooler. Select a place of use that is protected
from direct sunlight.
• The lid is locked when the handle is pushed back and
when carrying.
• To open the cooler box, pull the handle forward.
• Do not open the lid more often than required. Do not
leave the lid open more often than it is necessary. This
affects the cooling performance.
• The cooling duration depends on the ambient temper-
ature.
• The appliance is not suitable for permanent operation.
• The appliance can be connected to two different energy
sources.
- Alternating current: 220 – 240 V~ or
- Direct current: 12 V
• Use the switch to select an operating mode.
Operating Modes
NOTE:
To use the ECO or MIN functions, the appliance must be
connected to 220 – 240 V alternating current.
• In the MAX operating mode, cooling is at the highest
level. Use this operating mode if you want to cool the
food.
KB6011CBN_IM_01.2022
• The output is reduced in the operating mode ECO. Use
this mode if you want to cool for a longer period of time.
• In the MIN operating mode, cooling is performed at the
lowest level. Use this operating mode for food that has
already been precooled.

Using the Appliance

The switch for the operating mode, the AC connection
socket and the DC cable can be found at the backside of
the appliance.
Connection to the Alternating Current
1. Check to make sure that the mains voltage that you
want to use is 220 – 240 V~.
2. Plug the power cord for alternating current into the AC
socket on the appliance.
3. Connect the appliance to a properly installed earthed
socket.
4. Set the switch to MAX, MIN or ECO.
Connection to the Direct Current
1. Remove the power cord for the alternating current, if
necessary.
2. Turn on the engine of the motor vehicle.
3. Remove the DC cable from the cable storage compart-
ment at the backside of the appliance.
CAUTION:
The cable is firmly connected to the appliance. You
won't be able to remove it.
4. Connect the appliance to the cigarette lighter in the
motor vehicle.
5. Set the switch to MAX.
NOTE:
Protect the battery of your motor vehicle. Only run the
appliance in the motor vehicle while the engine is running.
End of Operation
There is no automatic shut-off. The appliance runs perma-
nently as long as it is connected to a power source.
1. Unplug the power cord from the socket or the cigarette
lighter.
2. If you have operated the appliance with alternating cur-
rent, unplug the connection cable from the appliance.
29
13.01.22