Unpacking The Appliance - BOMANN KT 6013 CB Bedienungsanleitung, Garantie

Unpacking the Appliance

1. Remove the appliance from the package.
2. Remove all packaging material such as films, filler, cable
holders and cardboard.
3. Check the delivery contents for completeness.
4. Should the package contents be incomplete or damages
be found, do not take the appliance into operation. Take
it immediately back to the dealer.
NOTE:
Dust or production residues can be located on the appli-
ance. We recommend to clean the appliance as described
under "Cleaning".
Scope of Delivery
1 Cooling bag
1 Connection cable for DC 12 Volt
Using the Appliance
General Notes
• Never place the appliance next to naked flames or other
heat sources.
• The mobile use of the appliance is possible wherever
there is an on-board 12 V power socket.
WARNING:
• Always disconnect the connection cable from the on-board
power socket before cleaning.
• Do not immerse the appliance in water! It could result in an elec-
tric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
1. Use a moist towel to clean the inside and the outside.
You may add a dishwashing liquid to the towel.
2. Dry it with a cloth afterwards.
Storage
• Clean the appliance as described and allow it to dry.
• We recommend to keep the appliance in the original
packaging if it will not be used for long periods.
• Always store the appliance out of the reach of children in
a dry, well ventilated place.
KT6013CB_IM
• The cooling duration depends on the ambient temper-
ature.
• The appliance is not suitable for permanent operation.
Electrical Connection
Connect the connection cable to an on-board 12 V power
socket.
NOTE:
Protect the battery of your motor vehicle. Only run the
appliance in the motor vehicle while the engine is running.
Terminating Operation
There is no automatic shut-off. The appliance runs perma-
nently as long as it is connected to a power source.
• Disconnect the connection cable from the on-board
socket.
Cleaning
Problem Possible cause
The No power supply.
appliance
is not
working.
The fuse in the plug
of the 12 V power
cord is faulty.
The on-board
power socket is
defective.
The appliance is
defect.
Troubleshooting
Solution
Check the connection
to the on-board power
socket.
Replace the fuse. You
can obtain one from a
specialized dealer.
Contact a specialist.
Consult our service de-
partment or an expert.
10.09.18
25