Set-Up; Commissioning; Inserting/Replacing The Batteries - Renkforce RF-DAB-Mono1 Bedienungsanleitung

8. Set-Up

When selecting the set-up location, please take into consideration the room layout such as the
whereabouts of the nearest socket, etc.
When selecting the set-up site, observe that direct sunlight, vibration, dust, heat, cold and
moisture must be avoided. There also must not be any strong transformers in the device's
proximity.
Do not drill or screw any additional screws into the casing to mount the device. It would
damage the product.
Make sure you position the device safely. Falling devices may pose a significant risk
of accident.
Due to the diversity of furniture paints and polishes used, it is possible that the
device's feet will leave visible residue on furniture due to chemical reaction. The
device therefore should not be placed on valuable furniture surfaces without any
suitable protection.
• Place the device on a level and stable surface.
• Completely pull out the aerial (11) and align it vertically.
• If reception is not satisfactory after connection and commissioning, change the alignment of
the aerial (11) or the site of setup of the device for best reception.

9. Commissioning

a) Inserting/Replacing the Batteries
For mains-independent operation, the device can be operated with four batteries type 1.5 V
Mignon (AA). Once a mains unit is connected to the port DC 5V (9), battery operation is turned
off automatically.
• Open the battery compartment (12) on the rear of the device.
• Insert four new type 1.5 V Mignon batteries (AA) in the battery compartment in the correct
polarity. The correct polarity is indicated in the battery compartment.
• Close the battery compartment again.
• If the device no longer works or if the display contrast deteriorates, the batteries are
discharged and must be replaced.
29