Blade Replacement; Cleaning And Maintenance - Probuilder 44025 Gebrauchsanweisung

Blade replacement

Open the blade shield using the handle (18), and fasten it
open.
Depress the spindle lock (23) to lock the saw blade. Turn
the blade by hand until it locks.
Release the lock nut (16) using an adjustable spanner and
remove the outer flange (15).
Remove the blade. Do not dispose of the blade in your do-
mestic refuse. Dispose of it correctly in accordance with
local legislation.
Remove any chips or sawdust from around the spindle and
flanges.
Fit the new blade, outer flange and lock nut. Check that the
blade rotation direction complies with that of the motor (10).
Release the spindle lock and blade shield.
The saw can be cleaned by wiping its exterior parts with a
damp cloth. Compressed air can be used to remove chips
and dirt from awkward corners.

Cleaning and maintenance

Clean the laser lens (13) with a cotton bud or soft, dry brush.
Never use corrosive or abrasive detergents, as they may
attack the plastic parts of the machine.
Check regularly that the carbon brushes (22) are in good
condition. If they are worn down, they should be replaced.
17
ENGLISH