Sensor Temperature Monitoring Function - Toshiba HWS-803XWHT6-E Installationshandbuch

Hydro Unit
11
SENSOR TEMPERATURE MONITORING
FUNCTION
The sensor sensing temperature is displayed on the
remote controller.
This function allows you to make sure whether the
sensor is installed properly.
Press the TEST
or more.
Select the function code with the TEMP.
buttons.
Press the TEST
Item
code
00 Control temperature (Hot water cylinder)
01 Control temperature (Zone1)
02 Control temperature (Zone2)
03 Remote controller sensor temperature
04 Condensed temperature (TC)
06 Water inlet temperature (TWI)
07 Water outlet temperature (TWO)
08 Water heater outlet temperature (THO)
09 Floor inlet temperature (TFI)
0A Hot water cylinder temperature (TTW)
0B Mixing valve position
OE Low pressure (Ps) × 100
Item
code
60 Heat exchange temperature (TE)
61 Outside air temperature (TO)
62 Discharge temperature (TD)
63 Suction temperature (TS)
65 Heat sink temperature (THS)
6A Current
6D Heat exchanger coil temperature (TL)
70 Compressor operation Hz
72 Number of revolutions of outdoor fan (lower)
73 Number of revolutions of outdoor fan (upper)
74 Outdoor PMV position × 1/10
39-EN
+ CL buttons for four seconds
button to exit the test mode.
Data name
Data name
Item
code
F0 Micro computer energized accumulation time × 100h
F1 Hot water compressor ON accumulation time × 100h
F2 Cooling compressor ON accumulation time
F3 Heating compressor ON accumulation time
Built-in AC pump operation accumulation
F4
time
Hot water cylinder heater operation
F5
accumulation time
Unit
F6 Backup heater operation accumulation time
°C
F7 Booster heater operation accumulation time
°C
09 Floor inlet temperature (TFI)
°C
0A Hot water cylinder temperature (TTW)
°C
0B Mixing valve position
°C
OE Low pressure (Ps) × 100
°C
°C
°C
°C
°C
step
MPa
Unit
°C
°C
°C
°C
°C
A
°C
Hz
rpm
rpm
pls
– 40 –
Installation Manual
Data name Unit
× 100h
× 100h
× 100h
× 100h
× 100h
× 100h
°C
°C
step
MPa