Technical Specifications - Kärcher IV 60/30 Betriebsanleitung

Loosen the fastening clams and sepa-
rate the filter from its insert.
Insert and secure the new filter in the re-
verse sequence of steps.
Troubleshooting
You can thus solve any problems that may
occur.
Motor (suction turbine) does not start
No electrical voltage.
Check cables, plugs and socket.
Protective motor switch was triggered.
Reset switch.
Suction capacity decreases slowly
Filter, nozzle, suction hose or suction pipe
may be blocked.
Check, clean the accessories, replace
the filter, if required.
Dust comes out during the vacuuming
Filter has not been fastened correctly or is
defective.
Check to see if filter is sitting properly;
replace if required.
Manometer shows a pressure level that
is not correct
Filter is blocked.
Switch off the appliance, clean the filter
or insert a new filter.
Warning
All checking and work on electrical parts
must be performed by an authorized elec-
trician. In the event of continuing faults,
contact Kärcher customer service.

Technical specifications

Appliance description
Type of protection
Container capacity
Voltage
Blower data
Power
Vakuum*
Air quantity
* with pressure limiting valve
Length x width x height
Cable length
Protective class
Power cord: Order No.
Power cord: Type:
Weight
Storage temperature
Humidity
Filter area
Values determined to EN 60335-2-69
Sound pressure level L
Uncertainty K
– 6
EN
870 x 640 x
6.649-317
pA
pA
IV 60/30
IP X4
60 l
400 V
3000 W
22,0 kPa
64 l/s
1650
8 m
I
H07RN-F
96 kg
-10...+40
°C
30...90 %
2,2 m
2
75 dB (A)
1 dB (A)
15