Attaching The Presser Foot Holder; Setting Spool Pins - Silvercrest SNMD 33 A1 Bedienungs- Und Sicherheitshinweise

Attaching the presser foot holder

a
b
1
e
3

Setting spool pins

D
A
A
C
e
c
d
f
2
g
4
B
Attention:
Turn power switch to off ("O") when
carrying out any of the above operations!
1. Raise the presser bar (a) with the
presser foot lifter. Attach the presser foot
holder (b) as illustrated.
2. Attaching the presser foot
Lower the presser foot holder (b) using
the presser foot lifter, until the cut-out (c)
is directly above the pin (d)
The presser foot (f) will engage
automatically.
3. Removing the presser foot
Raise the presser foot using the presser
foot lifter.
Raise the lever (e) and the foot
disengages.
4. Attaching the edge/ quilting guide
Attach the edge/ quilting guide (g) in the
slot as illustrated.
Adjust as needed for hems, pleats,
quilting, etc.
The spool pins are used for holding the
spools of thread when feeding the thread to
the machine.
To use, pull up the spool pins. Push down
for storage.
A. Upper thread
B. Hole
C. Tangle
D. Spool pin
Note:
When using thread which has tendency
to tangle around a spool pin (D), thread
through the hole (B) of spool pin as
shown. The hole should face the thread
spool.
Getting ready
GB/ IE 77