Inserting The Needle; Two-Step Presser Foot Lever - Silvercrest SNMD 33 A1 Bedienungs- Und Sicherheitshinweise

Getting ready

Inserting the needle

C
Two-step presser foot lifter
76 GB/ IE
D
A
B
Attention:
Turn power switch to off ("O").
Needles must be in perfect condition.
Change the needle regularly, especially if it
is showing signs of wear and causing
problems.
Insert the needle following the illustrated
instructions.
A. Loosen the needle clamp screw and
tighten again after inserting the new
needle.
B. The flat side of the shaft should be
towards the back.
C/D. Insert the needle as far up as it will go.
Only use fully-functional needles:
Problems can occur with:
- Bent needles
- Blunt needles
- Damage points
When sewing several layers or thick fabrics,
the presser foot can be raised a second
stage for easy positioning of the work. (A)